Piedodiet manu Google Translate 
Edimax BR-6204Wlg
Downloaded from the site of a firmware update 1.11. Went to the address 192.168.2.1 in the web interface for configuring the router. Went to Tools and there chose the Upgrade Firmware. Extract archive to the update via Browse chose the file and run the update. Time passed and I was shown a messageFAIL! Rebooted the router and the HORROR! He stopped working.
Symptoms: take turns flashing lights Power and WiFi, the web interface is not loaded in any way, pressing the Reset button does not lead to any result.
Appealed for help to the producer. Received from him a simple answer - "Press Reset"
Everything! Thought is that the restore will not work and has eye on eBay for a replacement. Thank God is not expensive.
But naryl the Internet is one solution, which decided to try out. Once it is I have not gone, but after a number of times all did not solve the problem and restore your router is already a new firmware.
I do not know why exactly but that's what did:
1. Established a local network interface on the computer 192.168.1.11 (mask 255.255.255.0; getway - 192.168.1.1; DNS - 192.168.1.1)
2. Put router in recovery mode: turn off power, press and hold Reset button, turn on, after a few seconds relase Reset button. (rusantro-both WiFi and Power lights are lit continuously)
3. Connect the LAN computer and one of the LAN ports on the spot (specifically the 2 nd port).
3. He went into the command prompt (Start - Run - cmd - OK) (rusantro -Windows XP or other Windows systems) and put this command:
tftp -i 192.168.1.6 put edimax.1.11.bin
(rusantro - instead edimax.1.11.bin need to specify the path where the file to be decompressed firmware update. I renamed the update file to edimax.1.11.bin and copied it to disk C: . The path I have received such: tftp -i 192.168.1.6 put C:\edimax.1.11.bin)
and the firmware installed.
"The successful transfer of 1565158 bytes in 2 cs, 782579 bytes/sec"
Next, open the web interface, which is preserved in the old configuration until the fall of the points already poured through the web a new firmware version 1.13 and now everything works fine. (rusantro - I have a slightly different happened. I turned off the router and plugged it again. LEDs blinked since and should have, but the web interface I get failed, although all of the computers directly connected to the router to the old settings. I clicked on the Reset button 20 sec. Router did restart and was able to connect to the web interface. Router settings have been reset to the factory. Run Quick Setup, configured everything as it was before the crash and now I have everything working)
Ierakstīt komentāru